Accumulation Roller Conveyors
Accumulation Roller Conveyors are used for the accumulation or buffering of your transport goods. There are two fundamental accumulation systems.
Accumulation with Backpressure: the transport goods run into each other and have physical contact. Manual separation is required at the end of the accumulation section of the conveyor.
Accumulation without Backpressure: the transport goods remain separated from each other throughout the accumulation section and additional separation at the end of the accumulation section of the conveyor is not required. Both accumulation systems belong to our standard product range.
When you do business with us you will have competent advisor on your side due to our broad selection load-bearing rollers, drive train systems and special roller conveyor profiles. We gladly develop effective, cost-optimized transport solutions tailored to your spatial conditions and specific merchandise.
The section below displays some of our roller conveyor variations: the load-bearing rollers are available in different finishes such as plastic, stainless steel, aluminum or steel:
Motorized Accumulation Conveyor with O-Belt Drive Train
Equipped with inlaid load-bearing rollers. This accumulation conveyor system creates minimal backpressure during the accrual process. The reduction of backpressure is made possible through the use of friction wheel-rollers, which are mounted onto the drive train.
Motorized Accumulation Conveyor with O-Belt Drive Train
Equipped with inlaid load-bearing rollers. This accumulation conveyor system creates no backpressure during the accrual process. The accumulation roller conveyor is divided into accumulation sections, which corresponds to the length of the transport good. The drive train of these accumulation sections is regulated to automatically and pneumatically switch off when required. The necessary control logistics are integrated into the light sensors.
Motorized Accumulation Conveyor with Drive Belt Drive Train
Equipped with screwed-in load-bearing rollers. This accumulation conveyor system creates minimal backpressure during the accrual process. Reinforcements are applied to the drive belt in uniform intervals so that the load-bearing rollers are propelled one after the other in such a way that the transport goods are conveyed forwards in a specific tact.
Motorized Tangential Accumulation Roller Conveyor
Equipped with screwed-in load-bearing rollers. This accumulation conveyor system creates minimal backpressure during the accrual process. The load-bearing rollers are equipped with an adjustable slip clutch, upon which the adjustment for the drive force of the load-bearing rollers is located.
Motorized Tangential Accumulation Roller Conveyor
Equipped with screwed-in load-bearing rollers. This accumulation conveyor system creates no backpressure during the accrual process. The accumulation roller conveyor is divided into accumulation sections, which corresponds to the length of the transport good. The drive train of these accumulation sections is regulated to automatically and pneumatically switch off when required. The necessary control logistics are integrated into the light sensors.